- ID孔径涂料 O形环制造 一次性点胶组件 光固化设备和测光表 单组分点胶 双组分点胶 喷涂系统和阀门 容积点胶系统 控制器、贮存器和点胶阀 散布设备 桶泵系统和附件 烟雾过滤 热熔胶 过程监控 运动控制系统
- 包装和纸张 医疗、卫生与药物配送—医用粘合剂 工业装配 建筑和家具—建筑粘合剂 水处理 电子和电气设备 电子设备组装 维护、维修或大修（MRO） 能量和公用设备 设备
- 乐泰® LOCA
本文来自：汉高乐泰胶水（中国）有限公司 Henkel Loctite官网 www.loctite.net/c1196.html
Editor: NORTH GROUP
Email To: firstname.lastname@example.org
More about :LOCTITE 98853
Loctite 98853 glue anti-seize compounds
Product Description of Loctite 98853
Loctite magic metal glue stick 98853 Pressure Seal Bars 113.4 g
Metal Magic glue stick rod is filled with steel powder epoxy adhesive, after kneading by hand to fill gaps or holes to plugging for 3 minutes, Fixture time is 10 minutes. It can be drilled, tapped, painted after curing paint. Suitable for tanks and pipes leak repair emergency seal can be used in the steel material pressure is less than 0.3MPa conditions plugging. You can fill the weld flat; small crack casting repair. For oversized bolt holes to fill. NSF61 standards. It is a steel reinforced Putty, can leak appeared on the vessel steel, iron, aluminum and other metal materials, pipes and some of the parts, cracks, blisters, defects, breakage, damage, etc. filled with adhesive. In addition, it can quickly produce, reproduce parts, models, model, repair peeling thread, sturdy after fixed, seals and various other forms of mounting bolts.
Mainly for the repair of cast iron and stainless steel parts, repair of casting defects, fill cracks, holes. Production of nuts, screws, repair worn threads; for metal equipment, tools, pipes, appliances and automotive body repair; does not shrink after curing, never rust; color after curing gray, metallic luster.
Before use, shall be repaired at around rust, dust, grease and other floating objects clean. Remove plastic tube colloid, the amount of cut desired, and the colloid core to sheath material of two different colors by hand to fully blend into one color (about 1 to 2 minutes) until smooth. Its hard compacted cement to mend and try to squeeze into the holes and cracks. After mixing the adhesive quickly reacted, 3 to 5 minutes after the start of colloidal slight fever cured, after 10-20 minutes, it will be very hard. Before curing clay-like form so that it does not drip when used, not flowing, easy to use. Winter cold areas should colloid and surface to be repaired properly heated to room temperature or slightly above.
Color: dark gray
Shear strength: ≥3.45LMS
Pressure shear strength (N / mm ^ 2) ISO 10123: Steel pins and ring: 82.7
Tensile strength: 17.2
Maximum temperature: 121 (℃)
Curing time: 10
Coating area (cm ^ 2 / 6mm thick / tube): 45
Aluminum (N / mm ^ 2) (acid etching) 0.125mm gap: 4.8